TUL Pynq Z2 FPGA Development Board

TUL PYNQ™-Z2 board, based on Xilinx Zynq SoC, is designed for the Xilinx University Program to support PYNQ (Python Productivity for Zynq) framework (please refer to the PYNQ project webpage at www.pynq.io) and embedded systems development. 

Best for learning FPGA development! 📖

Product Specification

ZYNQ XC7Z020-1CLG400C
　• 650MHz dual-core Cortex-A9 processor
　• DDR3 memory controller with 8 DMA channels and
　　4 High Performance AXI3 Slave ports
　• High-bandwidth peripheral controllers: 1G Ethernet,
　　USB 2.0, SDIO
　• Low-bandwidth peripheral controller:
　　SPI, UART, CAN, I2C
　• Programmable from JTAG, Quad-SPI flash,
　　and MicroSD card
　• Programmable logic equivalent to Artix-7 FPGA
　　• 13,300 logic slices, each with four 6-input LUTs
　　　and 8 flip-flops
　　• 630 KB of fast block RAM
　　• 4 clock management tiles, each with a phase
　　　locked loop (PLL) and mixed-mode clock
　　　manager (MMCM)
　　• 220 DSP slices
　　• On-chip analog-to-digital converter (XADC)
Memory
　• 512MB DDR3 with 16-bit bus @ 1050Mbps
　• 16MB Quad-SPI Flash with factory programmed
　　48-bit globally unique EUI-48/64™ compatible
　　identifier
　• MicroSD slot
Power
　• Powered from USB or 7V-15V external power source
USB and Ethernet
　• Gigabit Ethernet PHY
　• Micro USB-JTAG Programming circuitry
　• Micro USB-UART bridge
　• USB 2.0 OTG PHY (supports host only)
Audio and Video
　• HDMI sink port (input)
　• HDMI source port (output)
　• I2S interface with 24bit DAC with 3.5mm TRRS jack
　• Line-in with 3.5mm jack
Switches, Push-buttons and LEDs
　• 4 push-buttons
　• 2 slide switches
　• 4 LEDs
　• 2 RGB LEDs
Expansion Connectors
　• Two standard Pmod ports
　　• 16 Total FPGA I/O (8 shared pins with
　　　Raspberry Pi connector)
　• Arduino Shield connector
　　• 24 Total FPGA I/O
　　• 6 Single-ended 0-3.3V Analog inputs to XADC
　• Raspberry Pi connector
　　• 28 Total FPGA I/O (8 shared pins with Pmod
　　　A port)

More info and download links: http://www.tul.com.tw/ProductsPYNQ-Z2.html